Caution – Hearth and Home Technologies CB1200I-B User Manual

Page 19

Advertising
background image

R

Septemer 1, 2008

7014-083E

Page 19

CB1200-I Pellet Insert

B. Outside Air Kit Instructions

Parts Included in Kit: 1 piece of 2 inch x 3 ft. flex hose,
1 hose clamp and 1 rodent screen.

1. Measure distance from floor to air vent opening in appli-

ance and mark location on wall.

2. Use saw to cut opening in wall. Cut a 2-1/2 to 3 inches

(64-76mm) opening on inside wall and a 3 to 3-1/2 inch
(76-89mm) opening on outside of house.

3. Use hose clamp to secure flex pipe to collar assembly.

4. Slide trim ring over flex pipe and run pipe through wall.

5. Attach hose to outside termination cap with second

hose clamp.

6. Secure termination cap to outside surface.

7. Secure trim ring to interior wall.

Tools Needed: Phillips head screw driver; wire cutters;
hole saw or jig saw.

CAUTION

Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage

le ose

ose Cla

Collar
Asse

l

ri Rin

ose Cla

er ination

Ca Asse

l

Figure 19.1

Attach hose clamp to

intake air collar

Outside air

flex pipe

D. Optional Grille Installation

Figure 19.3

1. Remove grille from packaging.

2. Lift top up.

3. Align the 3 holes in the insert with the holes in the grille.

4. Use a Phillips screw driver to secure in place. It will be

necessary to go through the hole in the bag support shelf
to gain access to the screw. Figure 19.3.

5. Lower the top into position.

Bag Support Shelf

C. Adjustable Hopper Options

Depending on your installation, the hopper can be vertically
adjusted up to a maximum of 3-1/2 inches (89mm) and will
hold an additional 15 lbs of fuel.

To adjust hopper:

1. Using a Phillips head screw drive, remove all the screws

from the top of the hopper securing the top hopper piece
to the bottom hopper piece and insert body.

2. Adjust upward a maximum of 3-1/2 inches (89mm).

3. Mark location for new holes and drill new holes.

4. Secure hopper pieces together using screws removed in

step one.

5. See drawing on page 7, Figure 7.3.

Figure 19.2

Advertising