Hearth and Home Technologies CB1200I-B - Manual (Page 21)

R
Septemer 1, 2008 7014-083E Page 21
CB1200-I Pellet Insert
F. Panel and Trim Set
Standard Size: 30 inches H x 40 inches W (762mm x 1016mm)
Large Size: 33 inches H x 50 inches W (838mm x 1270mm)
Included in Kit: 2 side panels, 1 top panel, 2 side trim, 1
top trim, 2 corner brackets and fastener package.
Tools Needed Phillips and flat head screw drivers.
Top Trim
Corner
Bracket
Corner
Bracket
Left
Trim
Right
Trim
Right
Panel
Left
Panel
*Right Side
Curtain
*Left Side
Curtain
Top Panel
Figure 21.1
Figure 21.2
Figure 21.3
Figure 21.4
Figure 21.5
Figure 21.6
NOTE: *Right and left side curtains are shipped
with the insert.
1. Unpack and lay out parts face down (flanges up) on a non-
abrasive surface as shown in Figure 21.1. Install (1) 8-32
x 3/8 inch screw into bottom tab of side panel.
2. Set the large hole at bottom of side curtain over screw
installed in Figure 21.2.
3. Stand assembly on end and attach and install (1) 8-32 x 3/8
inch screw through tab in side panel and curtain. Figure
21.4. Lay face down as shown in Figure 21.5.
4. Align top panel to side panel setting clearance hole over
screw head in side panel/curtain assembly. Install (2) 8-32
x 3/8 inch screws through holes in side panel into top panel.
Figure 21.6. Complete for both sides.