Hearth and Home Technologies CB1200I-B - Manual (Page 23)

R
Septemer 1, 2008 7014-083E Page 23
CB1200-I Pellet Insert
G. Optional Brick Set Installation
H. Brick Clip Installation
1. Slide bottom of left rear brick in first; rotate top edge to-
ward rear of appliance and then rotate outer edge toward
rear of appliance, until brick slides into place. Figure 23.1.
Repeat for right rear brick.
2. Place left side brick along left side of firebox, making sure
chamfered (beveled) back edge fits snugly next to left rear
brick. Figure 23.2. Repeat with right side brick.
3. Complete brick set, correctly installed. Figure 23.4.
Figure 23.1
Figure 23.2
Figure 23.3
Figure 23.4
1. After the brick set has been installed, 2 brick clips need to
be installed on the outer edge of baffle to keep the brick
set in place. Remove the baffles from the appliance before
installing the brick clips.
2. Using pliers, bend the brick clip slightly past 90° in the
direction shown in Figure 23.4.
3. Position the brick clip as shown in Figure 23.4 and use pliers
to crimp around the outside edge of the baffle. Figure 23.5
shows the finished shape of the brick clip after being bent
around the outside edge of the baffle.
4. Slide the baffles back into place making sure that the brick
clip holds the brick out toward the wall of the firebox. Push
back on the sides so they keep the rear bricks in place.
Repeat for the opposite side.
Approximately
1 inch
Top outside
corner of Baffle
Outside edge
of Baffle
Brick Clip
Installed Clip
• Brick may have small wires protruding from
the back of brick.
WARNING
Risk of Injury.
Figure 23.5