Warning, E. glass replacement – Hearth and Home Technologies CB1200I-B User Manual

Page 36

Advertising

Page 36

7014-083E

September 1, 2008

CB1200-I Pellet Insert

E. Glass Replacement

• Glass is 5mm thick high temperature heat-

resistant ceramic glass.

• DO NOT REPLACE with any other material.

• Alternate material may shatter and cause

injury

WARNING

o otto ra e

oor Latc

Side

ra e

Center Posts

lass

Re ove oor

Latc irst

and t en Side ra e

oor ra e

s o n it

lass or lass

ra es

Re ove nuts fro otto ra e

Figure 36.2

Figure 36.1

• Remove door from appliance and place face down

on a protected surface to avoid scratching the door.

• Remove all door rope.

1. Replacing Center Glass

NOTE: DO NOT LET Air Wash Spacers fall down from

top frame when removing and replacing center
glass.

a. Be sure the appliance is allowed to cool, has been

unplugged and the exhaust blower is off.

b. Using a nut driver remove the (5) bottom nuts and

remove the bottom glass frame. Figure 36.2.

c. Slightly bend up and out of the way the 2 center posts

and slide the glass out the bottom.

d. Slide new glass in, reposition the 2 center posts and

re-install bottom glass frame.

e. Re-rope the door.

2. Replacing Side Glass

NOTE:

When removing the side glass with the door

latch, you must remove the door latch first
before removing the side frame. Use a pow-
ered Phillips head screw driver to remove the
4 screws.

a. Be sure the appliance is allowed to cool, has been

unplugged and the exhaust blower is off.

b. Remove side glass frame.

c. Loosen the top and bottom frame and slightly bend

up and out of the way.

d. Slide glass out the side and slide new glass in.

e. Re-install the side glass frame and tighten the top

and bottom frames.

f. Re-install the door latch, if applicable, and re-rope

the door.