HP 1055CMHP - Manual (Page 127)

Service Calibrations
5-11 HP DesignJets 1050C and 1055CM Printers Service Manual
3. Service Station
The purpose of this Service Calibration is to calibrate the Service
Station in relation to the Carriage Assembly.
Perform the Service Station Calibration whenever:
n Carriage Assembly is disassembled or replaced.
n Platen Assembly is disassembled or replaced.
n Service Station is disassembled or replaced.
Perform the Service Station Calibration as follows:
NOTE Make sure you load media bigger than A4 in to the Printer before
performing this calibration. Do NOT use any other type of media
apart from HP Coated or HP High Gloss Photo Paper.
1 In the Service Calibrations submenu, scroll to "3. Service Station"
and press Enter.
2 The following message will appear asking you to confirm the operation.
Select ACCEPT if you want to continue the Service Station Calibration, or
select CANCEL if you want to cancel the it. Press Enter once the selection
has been made
.
Top
Enter
Back
↑
↓
Press Enter
Service Calibrations
4. Roller mark position...
5. Pen to Paper Spacing...
1. Accuracy cal...
2. Line sensor cal...
3. Service station... Make Selection
3. Service Station
Cancel
Accept
Top
Enter
Back
↑
↓
Press Enter
Make Selection