HP 1055CMHP - Manual (Page 139)

Service Calibrations
5-23 HP DesignJets 1050C and 1055CM Printers Service Manual
3 If you selected to continue, then the following message appears on
the front panel if media is not loaded. You must load Media in to the
Printer to continue.
WARNING Do NOT use Clear Film, Vellum or Natural Tracing Paper.
4 The Printer will start to print the Alignment Pattern and the
following message will be displayed on the front panel:
5 Once the Pen Alignment calibration is completed, the following
message will be displayed on the front panel:
6 If the calibration fails Perform the Electronic Systems Test
⇒
Page
4-5.
perform this operation
Please, load paper to
and try again
Press ENTER to continue
Top
Enter
Back
↑
↓
Press Enter
Approximate
Aligning printheads
PRINTHEAD ACCESS
time remaining
6 min 30 sec
Press ENTER to continue
Top
Enter
Back
↑
↓
Press Enter
Pen Alignment
calibrated.