HP 1055CMHP - Manual (Page 267)

Removal and Installation
8-59 HP DesignJets 1050C and 1055CM Printers Service Manual
CAUTION The complete ink tube system is full of ink.
15. Now you can remove the complete Tubes System from the printer
by sliding the tubes from between the tube guides.
Restarting the printer
1 Turn the printer ON from the main power switch at the rear of the
printer and from the power switch on the front panel.
2. The front panel displays:
3. Press the Enter button.
4. Lift up the window and install four setup printheads into the
Printhead carriage. (Refer to the User’s Guide for details).
5. Install the Ink Cartridges. (Refer to the User’s Guide for details).
6. The front panel displays:
7. Wait for about 30 seconds.
8. Remove the setup printheads from the printer carriage.
9. Install the Printheads and the Printhead Cleaners (Refer to the
User’s Guide for details).
NOTE You must perform the following Service Calibrations after the
installation of the Tubes System.
n Calibrations Backup
⇒
Page 5-19.
n Pen Alignment
⇒
Page 5-22
.
C4704034
System Startup
Press Enter to Continue
C4704034
System Startup
Press Enter to Continue
C4704034
System Startup
Press Enter to Continue
C4704034
Initializing printer
Wait