HP 2103R-CSDI - Manual (Page 31)

Verifying Jumper Plug Positions 2-7
Verifying Jumper
Plug Positions
Verify the jumper plug positions on the ONline or ONcore Edge Router
module before proceeding with the installation procedure.
The Edge Router module is equipped with several jumper plugs. The
jumpers are factory-set to the appropriate settings. Do not modify the
jumper settings, except to restore the settings to the required positions.
CAUTION: If you modify any of the factory-set jumper positions, the Edge
Router module may not operate properly.
Table 2-3 lists the default jumper plug positions for the Edge Router
module. If you suspect that any of the jumper positions have been changed,
verify the plug positions using Table 2-3.
.
Table 2-3 Default Jumper Plug Settings
Jumper Jumper Plug Position
J1 ETH INT
J2 Removed
J4 Inserted
J5 Removed
J9 Removed
J10 WAN 0 EXT
J12 WAN 1 EXT
J13 Removed
J14 Inserted
J15 Removed
J16 Inserted
J17 Inserted