Using the show port command – HP 2103R-CSDI User Manual
Page 58
4-6
C
H
A
P
T
E
R
4:
M
O
N
I
T
O
R
I
N
G
E
D
G
E
R
O
U
T
E
R
M
O
D
U
L
E
O
P
E
R
A
T
I
O
N
Using the SHOW
PORT Command
The
SHOW PORT
command displays information about a single port or all
ports.
The syntax for the
SHOW PORT
command is:
SHOW PORT
slot.port
{verbose}
{no_verbose}
The following command displays verbose information for port 1 on an
Edge Router module installed in slot 1 of an ONcore hub:
ONcore> show port 1.1 verbose
Port Display for Module 6102M-SDEK:
Port
Mode
Status
Network
General Information
-----
------ -------
-------
----------------
01.01 LOGICAL OKAY ETHERNET_4 2103R-CSDI
Port Connector:
BACKPLANE
IP Address:
2.0.0.2
Subnetwork Mask:
ff.00.00.00
Station Address:
00-00-0c-c0-3d-63
Dip Network Setting:
ETHERNET_4
The following command displays verbose information for port 1 on an
Edge Router module installed in slot 4 of an ONline hub:
ONline> show port 4.1 verbose
Port Display for Module 5103R-CSD:
Port
Mode
Status
Network
General Information
----- --------
------
--------
----------------
04.01 LOGICAL
OKAY
ETHERNET_1
Port Connector:
BACKPLANE
IP Address:
151.104.15.39
Station Address:
Capabilities: -NONE-
Native Port Number:
0