HP XU700 - Manual (Page 115)

115
6 Tests and Error Messages
Error Message Summary
The following table summarizes the most significant of the problems that
can be reported.
0522h HDD # 2 not detected (but configured in CMOS) IDE Device # 2 Error
0523h HDD # 3 not detected (but configured in CMOS) IDE Device # 3 Error
0530h Found a drive on slave connector only (primary) IDE Device Error
0531h Found a drive on slave connector only (secondary) IDE Device Error
0600h Found less video memory than configured in CMOS Video Memory Error
0700h Found less DRAM memory than at previous boot System Memory Error
0711h Defective SIMM (module 1, bank 1) System Memory Error
0800h Found lower cache size than configured System Cache Error
0801h Cache self-test failure System Cache Error
0A00h Plug and Play video auto-setting failure (DDC hang) DDC Video Error
Code # Cause / Symptom Short message (US)
Message Explanation or Suggestions for Corrective Action
Operating system not found Check whether the disk, HDD, FDD or CD-ROM disk drive is
connected.
If it is connected, check that it is detected by POST.
Check that your boot device is enabled on the Setup Security
menu.
If the problem persists, check that the boot device contains the
operating system.
Missing operating system If you have configured HDD user parameters, check that they are
correct. Otherwise, use HDD type “Auto” parameters.
Resource Allocation Conflict -PCI device
0079 on system board Clear CMOS.
Video Plug and Play interrupted or
failed. Re-enable in Setup and try again You may have powered your computer Off/On too quickly and the
computer turned off Video plug and play as a protection.
System CMOS checksum bad - run
Setup CMOS contents have changed between 2 power-on sessions. Run
Setup for configuration.
No message, system “hangs” Check that the main memory modules are correctly set in their
sockets.