Clearing the cmos – HP XU700 User Manual
Page 89
89
5 HP BIOS
Clearing the CMOS
Clearing the CMOS
1 Turn off the PC Workstation, disconnect the power cord and all cables,
then remove the cover.
2 Set the system board switch
8
to the
ON
position.
3 Replace the cover, and reconnect the power cord and video cable.
4 Reboot the PC Workstation. A message similar to the following will be
displayed:
“Configuration has been cleared, set switch Clear to the
ON position before rebooting.”
5 Turn off the PC Workstation, disconnect the power cord and video cable,
and remove the cover.
6 Set the system board switch
8
to the
OFF
position.
7 Replace the cover, and reconnect the power cord and data cables.
8 Switch on the PC Workstation. Run the Setup program by pressing
F2
.
Then press
F9
, the CMOS default values will be automatically downloaded
and saved.
9 Press
Esc
to save the configuration and exit from the Setup program.