Hitachi PJ-TX100 - Manual (Page 16)

16
Operating
Recalling your adjustment
This projector can memorize 4 settings by the MY
MEMORY function of the PICTURE menu
( 20 ) .
Pressing the MEMORY button (remote control) calls the
settings and adjusts the current picture.
The memory which is not registered is skipped. When
there is no memory registered, the picture isn't adjusted.
1. Press the MEMORY button.
Each time you press the MEMORY button, one of
memorized settings comes in the order below.
LOAD1 LOAD2 LOAD3 LOAD4
Adjusting the picture (brightness, contrast, color)
Brightness and contrast can be adjusted using each (+)
and (-) button (remote control). At a video signal, the
color can also be adjusted.
1. Press the (+) or (-) button under the item indication
to adjust. Use the (+) button to increase the item, or
use the (-) button to decrease the item.
A dialog will appear on the screen to aid you in
adjusting the item to adjust. You can inactivate the
display using the item "MESSAGE" of the SCREEN
menu
(
27
) .
2. If you don't do anything, the dialog will automatically
disappear after about 5 seconds.
POWER LIGHT
OPT BLK
ASPECT
MENU
BRIGHT CONTRAST COLOR
IRIS
MODE MEMORY
ENTER
RESET
DVI PC AUTO
COMPO S-VIDEO VIDEO
MENU
BRIGHT CONTRAST COLOR
RESET
POWER LIGHT
OPT BLK
ASPECT
MENU
BRIGHT CONTRAST COLOR
IRIS
MODE MEMORY
ENTER
RESET
DVI PC AUTO
COMPO S-VIDEO VIDEO
POWER LIGHT
OPT BLK MODE MEMORY