Hitachi PJ-TX100 - Manual (Page 22)

22
Multifunctional settings
IMAGE Menu IMAGE Menu
Item Description
ASPECT
Select an Aspect Ratio using the ▲/▼ buttons:
At a COMPUTER input:
4:3 16:9 NORMAL
• The NORMAL keeps the original aspect ratio of the input signal.
• At a COMPUTER input, selecting an aspect ratio may display the
message“SYNC IS OUT OF RANGE”. In this case, please select
one of other aspect ratios.
At a DVI-D input:
4:3 16:9 WIDE MOVIE1 MOVIE2 NORMAL
At a VIDEO input, a S-VIDEO input or a COMPONENT VIDEO
input:
4:3 16:9 WIDE MOVIE-1 MOVIE-2
• At a COMPONENT VIDEO input of 16:9 HD signal of 1125i(1080i)/
750p(720p), only 16:9 can be selected.
At no input.:
4:3 16:9
OVER SCAN
Adjust the over-scan ratio using the ▲/▼ buttons. :
Small Large
memo This item can be selected only at a video signal.
memo When this adjustment is too large, certain degradation may
appear at the frame area of the picture. In such a case, please
adjust small.
V POSITION
Adjust the vertical position using the ▲/▼ buttons. :
Up Down
memo This item cannot be selected only at a DVI-D signal.
H POSITION
Adjust the horizontal position using the / buttons. :
Left Right
memo This item cannot be selected only at a DVI-D signal.
H PHASE
Adjust the horizontal phase to eliminate fl icker using the ▲/▼
buttons. :
Right Left
memo This item can be selected only at a RGB signal or a
component video signal.
With the IMAGE menu, the items shown in the table below
can be performed. Perform each operation in accordance
with the instructions in the table below.
MENU [RGB] :SELECT
PICTURE
IMAGE
INPUT
SETUP
SCREEN
OPTION
EASY MENU ASPECT
OVER SCAN
V POSITION
H POSITION
H PHASE
H SIZE
AUTO ADJUST 4:3
95
25
142
16
1344