Hitachi PJ-TX100 - Manual (Page 46)

4
Connecting the power supply / Putting batteries into the remote control
Connecting the power supply Connecting the power supply
WARNING ►Please use extra caution when connecting the power cord as
incorrect or faulty connections may result in fi re and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, contact
your dealer to newly get correct one.
• Only plug the power cord into an outlet rated for use with the power cord's
specifi ed voltage range.
• Never modify the power cord. Never attempt to defeat the ground connection of
the three-pronged plug.
1. Connect the connector of the power cord to the
AC inlet of the projector.
2. Firmly plug the power cord's plug into the outlet.
Putting batteries into the remote control Putting batteries into the remote control
WARNING ►Always handle the batteries with care and use them only as
directed. Improper use may result in battry explosion, cracking or leakage, which
could result in fi re, injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified. Do not use batteries of different
types at the same time. Do not mix a new barrty with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a
battey.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not allow a battery in a fi re or water. Keep batteries in a dark, cool and dry play.
• If you observe a leakage of a battery, wipe out the flower and then replace a
battery. If the fl ower adheres your body or clothes, rinse well with water immediately.
1. Remove the battery cover.
2. Insert the batteries.
Align and insert the two AAA batteries according
to their plus and minus terminals as indicated in the
remote control.
3. Close the battery cover.
AC
inlet
Power
outlet