HP GRACO OR PRO TI1681A - Manual (Page 6)

Warning
6 309293J
WARNING
Equipment Misuse Hazard
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and
result in a serious injury.
• This equipment is for professional use only.
• Read all manuals, tags, and labels before operating the equipment.
• Use the equipment only for its intended purpose. If you are uncertain, call your Graco distribu-
tor.
• Do not alter or modify equipment. Use only genuine Graco parts and accessories.
• Do not operate the power supply above 60 kV. Use only Graco Part No. 244542 Power Supply
with this gun.
• Check the equipment daily. Repair or replace worn or damaged parts immediately.
• Do not exceed the maximum working pressure of the lowest rated system component. Maxi-
mum working air and fluid pressure of this equipment is 100 psi (0.7 MPa, 7.0 bar).
• Use fluids and solvents that are compatible with the equipment wetted parts. See the Techni-
cal Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warn-
ings.
• Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180
°
F (82
°
C) or below -40
°
F (-40
°
C).
• Wear hearing protection when operating this equipment.
• Comply with all applicable local, state, and national fire, electrical, and other safety regula-
tions.
Pressurized Equipment Hazard
Spray from the gun, hose leaks, or ruptured components can splash fluid in the eyes or on the skin
and cause serious injury.
• Do not point the spray gun at anyone or at any part of the body.
• Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
• Follow the Pressure Relief Procedure, page 20, when you stop spraying and before cleaning,
checking, or repairing equipment.
• Check hoses and couplings daily. Replace worn, damaged, or loose parts immediately.
• Tighten all fluid connections before each use.