HP 3550 - Manual (Page 138)

7. Rotate the blue side of the pickup roller until it clicks into place.
8. Replace Tray 2.
9. Turn the printer on. After a short time, the printer control panel might display the
message NEW FUSER KIT.
10. If the message NEW FUSER KIT appears, go to step 11. If the message does not
appear, you must reset the fuser count. See To reset the fuser count .
11. On the printer control panel, press to highlight YES, and then press to select it. The
fuser count is reset and the printer is ready to use.
NOTE If you want to continue printing past the end-of-life message, the fuser kit count must be
reset using the printer control panel. Please note that the end-of-life message is provided as
a customer service, and printing past it is likely to result in print quality degradation in the
near future. Once the fuser kit count has been reset after an end-of-life message, feedback
on the kit's remaining life will be incorrect until the kit is replaced and the count is reset again.
126 Chapter 7 Maintenance ENWW