HP 3550 - Manual (Page 162)

Control panel message Description Recommended action
REPLACE SUPPLIES
alternates with
For status press
At least one supply item is out and
needs to be replaced and another supply
item is either out or low. 1. Press to identify which supplies
should be replaced.
2. Press for help.
or
See Replacing supplies and parts for
more information.
See Supplies and accessories for more
information.
REPLACE SUPPLIES
alternates with
To continue press
More than one supply item is low, and
the SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP. 1. Press to identify which supplies
should be ordered.
2. Order the identified supplies.
3. Press to continue printing.
See Supplies and accessories for more
information.
REPLACE TRANSFER KIT
alternates with
To continue press
The transfer unit is near end of life and
the SUPPLIES LOW setting in SYSTEM
SETUP is set to STOP. 1. Order the transfer kit.
2. Press to continue printing.
See Supplies and accessories for more
information.
REPLACE TRANSFER KIT
For help press
The transfer unit is at end of life. Press for help.
or
See Replacing the transfer kit for more
information.
See Supplies and accessories for more
information.
Request accepted
please wait
The printer has accepted a request to
print an internal page, but the current job
must finish printing before the internal
page will print. No action necessary.
Resend
upgrade
The firmware upgrade was not
completed successfully. Attempt upgrade again. You might need
to use the parallel port to send the
upgrade file.
Resetting Kit Count YES was selected in the RESET
SUPPLIES menu to reset the counts for
any of the supplies that cannot be
detected as new. No action necessary.
Restoring
factory settings
The printer is restoring factory settings. No action necessary.
Restoring... The printer is restoring settings. No action necessary.
Control panel messages (continued)
150 Chapter 8 Problemsolving ENWW