HP T2200 - Manual (Page 19)

Installation 19
2. Connect the battery lead to the battery terminal.
NOTE: A small amount of arcing may occur when connecting the batteries. This is normal and
does not damage the unit or present any safety concern.
3. Replace the UPS front bezel.
4. Attach the RETMA rail covers.
NOTE: The HP logo and product name are printed on the RETMA rail covers; therefore, the HP
logo badge is only used for a tower installation/configuration.
Selecting the UPS voltage configuration
Using a small tool, position the DIP switches according to the desired voltage configuration and charge
rate as identified on the rear panel of the UPS and in the following table.