HP T2200 - Manual (Page 21)

Installation 21
CAUTION: Use only the computer interface cable supplied with the UPS to connect the
communications port to the host computer.
CAUTION: Using a USB to serial converter cable will damage the UPS.
Connect the UPS to a host computer using either the USB cable or the DB9 serial cable included with the
UPS. Install HP Power Manager software 4.1 or later on the host computer. See the HP website
( http://www.hp.com/go/rackandpower ) to download the latest version of HP Power Manager.
IMPORTANT: If using HPPM, connect the Management Server to an unswitched output
receptacle (" UPS R/T2200 INTL rear panel " on page 9 , " UPS R/T2200 NA/JPN/TWN rear
panel " on page 8 ), and then set the Management Server as the last device to shutdown,
ensuring that all connected load devices are shutdown gracefully.
NOTE: To install and configure the software, see the software user guide. The software user
guide is available for download from the HP website
(
http://www.hp.com/go/rackandpower ).
Connecting the serial communications port
CAUTION: Use only the computer interface cable supplied with the UPS to connect the
communications port to the host computer.
CAUTION: Using a USB to serial converter cable will damage the UPS.
IMPORTANT: Power management software requires the communications port to be
appropriately cabled to the host computer.
Connecting the USB communications port