Hearth and Home Technologies 8000TR-OAK - Manual (Page 40)

Heat & Glo • 8000TR-OAK, 8000TR-OAK-IPI, 8000TRLP-OAKIPI • 2057-900 Rev. P • 11/08 40
PILOT
PLATE
Figure 9.14
Note: Ensure pilot plate is in place. This will ensure pilot
stability (see Figure 9.14)
E. Checking Pilot Plate
Figure 9.13 Re-install grate in unit
RE-INSTALL
INTO THE UNIT
D. Completing Grate Set-up
1. Straighten the tabs on the grate bracket (see Figure
9.12) and remove grate from unit.
2. Remove grate bracket (see Figure 9.12) by bending it
back and forth until it breaks. Discard grate bracket.
3. Remove 4 tabs holding base refractory (see Figure
9.12) by bending tabs back and forth until they break.
4. Reinstall grate into unit (see Figure 9.13).
Figure 9.12 Removing Grate
REMOVE GRATE
REMOVE GRATE BRACKET
REMOVE TAB HOLDING DOWN
BASE REFRACTORY (4 PLACES)
STRAIGHTEN TO
REMOVE GRATE