Appliance setup – Hearth and Home Technologies 8000TR-OAK User Manual

Page 53

Advertising
background image

Heat & Glo • 8000TR-OAK, 8000TR-OAK-IPI, 8000TRLP-OAKIPI • 2057-900 Rev. P • 11/08

53

A. Remove Fixed Glass Assembly

See Section 14.H.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the
fi rebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.

E. Install the Refractory

Install optional refractory following instructions in refractory
kit.

F. Ember Placement

WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.

Ember material is shipped with this gas appliance. To place
the ember material:

• Embers CANNOT be placed directly over ports. Care

should be taken not to cover the lighting trail of ports
(from back to front).

• Place dime-size pieces of Glowing Embers® just in front

of the port trail, but not on or in between the ports (see
Figure 14.1). Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.

Figure 14.1 Placement of Embers

• Place Mystic Embers on areas of base refractory away

from port holes. Use this material to give the appliance
a realistic ash bed.

• Save the remaining ember materials for use during

appliance servicing. The embers provided should be
enough for 3 to 5 applications.

14

14

Appliance Setup

EMBER

MATERIAL

DO NOT

PLACE EMBER MATERIAL BETWEEN

BACK ROW OF BURNER PORTS AND BACK

EDGE OF BURNER. (EMBERS IN THIS

AREA WILL CAUSE SOOTING.)

Advertising
This manual is related to the following products: