HP 6200YL - Manual (Page 120)

IPv6 Management Features
SNTP and Timep
where the address is on VLAN 10, configured on the switch, you would enter
this command at the global config level, as shown below.
ProCurve(config)# ip timep manual
fe80::215:60ff:fe7a:adc0%vlan10
N o t e In the preceding example, using a link-local address requires that you specify
the local scope for the address; VLAN 10 in this case. This is always indicated
by
%vlan followed immediately (without spaces) by the VLAN identifier. For
a global unicast address, you would enter the address without the %vlan suffix.
Syntax:. show timep
Displays the current Timep configuration, including the
following:
Time Sync Mode: Indicates whether timesync is disabled or set
to either SNTP or Timep. (Default: Disabled)
Timep Mode: Indicates whether Timep is configured to use a
DHCP server to acquire a Timep server address or to use a
statically configured Timep server address.
Server Address: Lists the currently configured Timep server
address.
Poll Interval (min) [720]: Indicates the interval between
consecutive time requests to the configured Timep server.
For example, the show timep output for the preceding ip timep manual
command example would appear as follows:
ProCurve(config)# sho timep
Timep Configuration
Time Sync Mode: Timep
TimeP Mode [Disabled] : Manual
Server Address : fe80::215:60ff:fe7a:adc0%vlan10
Poll Interval (min) [720] : 720
Figure 5-7. Example of Show Timep Output with an IPv6 Server Address Configured
5-16