HP 6200YL - Manual (Page 225)

IPv6 Access Control Lists (ACLs)
Configuration Commands
Note: For more on how prefix lengths are used in IPv6
ACLs, refer to “How an ACE Uses a Prefix To Screen Packets
for SA and DA Matches” on page 8-32.
< any | host < DA > | DA/prefix-length >
This is the second instance of addressing in an IPv6 ACE. It
follows the first (SA) instance, described earlier in this
section, and defines the destination IPv6 address (DA) that a
packet must carry to have a match with the ACE.
• any — Allows IPv6 packets to any IPv6 DA.
• host < DA > — Specifies only packets having DA as the
destination address. Use this criterion when you want to
match only the IPv6 packets for a single DA.
• DA/prefix-length — Specifies packets intended for one or
more contiguous subnets or contiguous addresses within a
single subnet. The prefix length is in CIDR format and
defines the number of leftmost bits to use in determining a
match. (Refer to “Using CIDR Notation To Enter the IPv6
ACL Prefix Length” on page 8-41.) In a given ACE, the DA
prefix length defines how many leftmost bits in a packet’s
DA must exactly match the DA configured in the ACE.
Example: Refer to “Examples of Prefix-Length
Applications” in the presiding syntax description.
[ dscp < codepoint | precedence >]
This option follows the DA to include a DSCP codepoint or
precedence as a matching criteria.
codepoint: Supports these codepoint selection options:
8-49