HP 6200YL - Manual (Page 110)

IPv6 Management Features
IPv6 Telnet Operation
IPv6 Telnet Operation
This section describes Telnet operation for IPv6 on the switch. For IPv4 Telnet
operation, refer to the Management and Configuration Guide for your
switch.
Outbound Telnet to Another Device
Syntax: telnet < link-local-addr >%vlan< vid > [oobm]
telnet < global-unicast-addr > [oobm]
Outbound Telnet establishes a Telnet session from the switch
CLI to another IPv6 device, and includes these options.
• Telnet for Link-Local Addresses on the same VLAN requires
the link-local address and and interface scope:
< link-local-addr >: Specifies the link-local IPv6 address of
the destination device.
%vlan< vid >: Suffix specifying the interface on which the
destination device is located. No spaces are allowed in the
suffix.
• Telnet for Global Unicast Addresses requires a global unicast
address for the destination. Also, the switch must be
receiving router advertisements from an IPv6 gateway
router.
< global-unicast-addr >: Specifies the global IPv6 address of
the destination device.
For switches that have a separate out-of-band management
port, the
oobm parameter specifies that the Telnet traffic will
go out from the out-of-band management interface. If this
parameter is not specified, the Telnet traffic goes out from the
data interface. The oobm parameter is not available on
switches that do not have a separate out-of-band management
port. Refer to Appendix I, “Network Out-of-Band Management”
in the
Management and Configuration Guide for more
information on out-of-band management.
For example, to Telnet to another IPv6 device having a link-local address of
fe80::215:60ff:fe79:8980 and on the same VLAN interface (VLAN 10), you
would use the following command:
5-6