HP 6200YL - Manual (Page 129)

IPv6 Management Features
SNMP Management for IPv6
SNMP Configuration Commands Supported
IPv6 addressing is supported in the following SNMP configuration commands:
For more information on each SNMP configuration procedure, refer to the
“Configuring for Network Management Applications” chapter in the current
Management and Configuration Guide
for your switch.
SNMPv1 and V2c
Syntax:. snmp-server host < ipv4-addr | ipv6-addr > < community-name >
[none | all | non-info | critical | debug] [inform [retries < count >]
[timeout < interval >]]
Executed at the global config level to configure an SNMP trap
receiver to receive SNMPv1 and SNMPv2c traps, SNMPv2c
informs, and (optionally) event log messages
snmp-server listen <oobm|data|both>
For switches with a separate out-of-band management port,
specifies whether the switch listens for SNMP traps on the out-
of-band management interface, the data interface, or both.
SNMPv3
Syntax: snmpv3 targetaddress < name > params < parms_name >
<ipv4-addr | ipv6-addr>
[addr-mask < ip4-addr >]
[filter < none | debug | all | not-info | critical>]
[max-msg-size < 484-65535 >]
[port-mask < tcp-udp port >]
[retries < 0 - 255 >]
[taglist <tag_name> ]
[timeout < 0 - 2147483647 >]
[udp-port port-number]
Executed at the global config level to configure an SNMPv3
management station to which notifications (traps and informs)
are sent.
5-25