Ip preserve for ipv6 – HP 6200YL User Manual
Page 132
IPv6 Management Features
IP Preserve for IPv6
The
show snmpv3 targetaddress command displays the configuration (including
the IPv4 or IPv6 address) of the SNMPv3 management stations to which
notification messages are sent.
ProCurve(config)# show snmpv3 targetaddress
snmpTargetAddrTable [rfc2573]
Target Name
IP Address
Parameter
------------------------- ---------------------- ---------------------------
1
15.29.17.218
1
2
15.29.17.219
2
PP.217
15.29.17.217 marker_p
PP.218
2620:0:260:211
:217:a4ff:feff:1f70 marker_p
An IPv6 address is
displayed on two lines.
Figure 5-9. “show snmpv3 targetaddress” Command Output with IPv6 Address
IP Preserve for IPv6
IPv6 supports the IP Preserve feature, which allows you to copy a configura
tion file from a TFTP server to multiple switches without overwriting the IPv6
address and subnet mask on VLAN 1 (default VLAN) in each switch, and the
Gateway IPv6 address assigned to the switch.
To configure IP Preserve, enter the
ip preserve statement at the end of the
configuration file that will be downloaded from a TFTP server. (Note that you
do not invoke IP Preserve by entering a command from the CLI).
5-28