HP 6200YL - Manual (Page 162)

Multicast Listener Discovery (MLD) Snooping
Configuring MLD
Configuring MLD
Several CLI commands are available for configuring MLD parameters on a
switch.
Enabling or Disabling MLD Snooping on a VLAN
Syntax: [no] ipv6 mld
Note: This command must be issued in a VLAN context.
This command enables MLD snooping on a VLAN. Enabling
MLD snooping applies the last-saved or the default MLD
configuration, whichever was most recently set.
The [no] form of the command disables MLD snooping on a
VLAN.
MLD snooping is disabled by default.
For example, to enable MLD snooping on VLAN 8:
ProCurve# config
ProCurve(config)# vlan 8
ProCurve(vlan-8)# ipv6 mld
To disable MLD snooping on VLAN 8:
ProCurve(vlan-8)# no ipv6 mld
7-8