HP 6200YL - Manual (Page 184)

IPv6 Access Control Lists (ACLs)
Overview of Options for Applying IPv6 ACLs on the Switch
— Continued from preceding page. —
Action Command(s) Page
Enter a Remark ProCurve(config)# ipv6 access-list < name-str > 8-69
ProCurve(config-ipv6-acl)# remark < remark-str > 8-72
Remove a Remark:
– Immediately After
Entry ProCurve(config-ipv6-acl)# no remark
– After entry of an
ACE ProCurve(config-ipv6-acl)#no < seq-# > remark
Delete an IPv6 ACL ProCurve(config)# no ipv6 access-list < name-str > vlan 8-62
Command Summary for Enabling, Disabling, and
Displaying ACLs
Enable or Disable an
IPv6 VACL ProCurve(config)# [no] vlan < vid > ipv6 access-group < name-str > vlan
Enable or Disable a
Static Port ACL ProCurve(config)# [no] interface < port-list | trkx > ipv6 access-group < name-str > in
ProCurve(eth-< port-list >| trkx >)# [no] ipv6 access-group < name-str > in
Displaying ACL Data ProCurve(config)# show access-list
ProCurve(config)# show access-list < acl-name-str > [config]
ProCurve(config)# show access-list config
ProCurve(config)# show access-list ports < port-list >
ProCurve(config)# show access-list vlan < vid >
ProCurve(config)# show access-list radius < port-list | all >
ProCurve(config)# show access-list resources 8-75
8-8