HP 6200YL - Manual (Page 244)

IPv6 Access Control Lists (ACLs)
Editing an Existing ACL
ProCurve(config)# show access-list My-List config
ipv6 access-list "My-List" ACL Before Deleting an ACE
10 permit ipv6 fe80::100/128 ::/0
20 deny ipv6 fe80::110/128 fe80::/124
30 deny ipv6 fe80::111/128 fe80::/124
40 permit ipv6 ::/0 ::/0
exit
ProCurve(config)# ipv6 access-list My-List
ProCurve(config-ipv6-acl)# no 30
ProCurve(config-ipv6-acl)# show access-list My-List config
Enters the IPv6 ACL (config-ipv6-acl)
context for “My-List”.
This command deletes the ACE at line 30.
The ACE at line 30 has been removed.
ipv6 access-list "My-List" ACL After Deleting the ACE at Line 20
10 permit ipv6 fe80::100/128 ::/0
20 deny ipv6 fe80::110/128 fe80::/124
40 permit ipv6 ::/0 ::/0
exit
Figure 8-21. Example of Deleting an ACE from An IPv6 ACL
Resequencing the ACEs in an IPv6 ACL
This action reconfigures the starting sequence number for ACEs in an IPv6
ACL, and resets the numeric interval between sequence numbers for ACEs
configured in the ACL.
Syntax: ipv6 access-list resequence < identifier > < starting-seq-# > < interval >
Resets the sequence numbers for all ACEs in the ACL.
< starting-seq-# > : Specifies the sequence number for the first
ACE in the list. (Default: 10; Range: 1 - 2147483647)
< interval > : Specifies the interval between consecutive sequence
numbers for the ACEs in the list. (Default: 10; Range: 1 -
2147483647)
1. To view the current sequence numbering in an ACE, use show access-list
config or show access-list < identifier > config.
2. Use the command syntax (above) to change the sequence numbering.
This example resequences the “My-List” ACL at the bottom of figure 8-21 so
that the list begins with line 100 and uses a sequence interval of 100.
8-68