Dns resolver for ipv6, Dns configuration, Dns configuration -10 – HP 6200YL User Manual

Page 290

Advertising
background image

IPv6 Diagnostic and Troubleshooting
DNS Resolver for IPv6

DNS Resolver for IPv6

The Domain Name System (DNS) resolver is designed for local network
domains where it enables use of a host name or fully qualified domain name
to support DNS-compatible commands from the switch. Beginning with soft­
ware release K.13.01,DNS operation supports these features:

dual-stack operation: IPv6 and IPv4 DNS resolution

DNS-compatible commands:

ping, ping6, traceroute, and traceroute6

multiple, prioritized DNS servers (IPv4 and IPv6)

DNS Configuration

Up to three DNS servers can be configured. The addresses must be prioritized,
and can be for any combination of IPv4 and IPv6 DNS servers.

N o t e

This section describes the commands for configuring DNS operation for IPv6
DNS applications. For further information and examples on using the DNS
feature, refer to “DNS Resolver” in appendix C, “Troubleshooting”, in the
current Management and Configuration Guide for your switch.

Syntax:. [no] ip dns server-address priority < 1 - 3 > < ip-addr > [oobm}

Used at the global config level to configure the address and
priority of a DNS server. Allows for configuring up to three
servers providing DNS service. (The servers must all be acces­
sible to the switch.) The command allows both IPv4 and IPv6
servers in any combination and any order of priority.

priority < 1 - 3 >: Identifies the order in which the specified DNS
server will be accessed by a DNS resolution attempt. A resolu­
tion attempt tries each configured DNS server address, in
ascending order of priority, until the attempt is successful or
all configured server options have been tried and failed. To
change the priority of an existing server option, you must
remove the option from the switch configuration and re-enter
it with the new priority. If another server address is config­
ured for the new priority, you must also remove that address
from the configuration before re-assigning its priority to
another address.

— Continued on the next page. —

9-10

Advertising
This manual is related to the following products: