Hawking Technology HNC720G - Manual (Page 25)

1. Click on “Configuration” on the homepage.
2. Click on “Application” in the left column.
3. Check the weekdays as desired and give the period from "Snapshots begin" to "Snapshots end" to monitor the
triggering conditions everyday.
4. Check the “Event operation” box. The triggering condition can be set to detected motion or the status of the attached
device.
5. Set the delay before detecting the next event to avoid continuous false alarms following the original event.
6. Set the delay to take snapshots after the event to capture the direction of the moving objects.
Send snapshots when motion is detected
If no external sensor is available, the Administrator can use the built-in motion detection to monitor any movement and
send snapshots via email for security check.
7. Click on “Motion detection” in the left column.
8. Check the “Enable motion detection” box at the top.
9. Click on “New” to have a new motion detection window to monitor video.
10. Type in a name to identify the new window.
11. Use the mouse to click, hold, and drag the window corner to resize it, or do the same to the title bar to move the
window.
12. Fine-tune using the “Sensitivity” and “Percentage” fields to best suit the camera’s environment. Higher
”Sensitivity” will help to detect even the slightest amount of motion. Higher “Percentage” discriminates smaller
objects. In other words, the higher the sensitivity, the more easily motion will be detected. The higher the
percentage, the more difficult it will be to detect small moving objects. (Therefore, by increasing the percentage,
you will be able to exclude minor, unnecessary motions, if desired.)
25