Hawking Technology HNC720G - Manual (Page 42)

Remote Controller
The network camera comes with a remote controller to command its pan/tilt and other functions. The direction control
area provides the same functions as you find on the camera’s homepage. The Pan/Patrol/Stop functions are also the same
as on the homepage.
Direction control
area
Auto movement
control area
Auto Patrol: This button commands the camera to patrol between the preset positions on the patrol list that was set on the
“Camera control page”. After each patrol cycle, the camera stops at the original starting position.
Auto Pan: This button commands the camera to pan from the current position to the left-most or right-most positions and
back. After panning both vertical end positions, the camera would stop at the original starting position.
Center: This calibrates the camera’s position to aim at the center as the camera boots up.
Stop: This stops the auto movements (auto pan & auto patrol) of the camera.
Viewing System Log
Click on the link on the configuration page to view the system log file. The content of this file provides useful
information about configuration and connections after system boot-up.
Viewing System Parameters
Click on this link on the configuration page to view the entire system’s parameter set. The content is the same as those in
CONFIG.INI.
42