Hawking Technology HNC720G - Manual (Page 43)

Factory default
“Factory default”
Click on this link on the configuration page to restore factory default settings. Any changes made so far will be lost and
the system will be reset to the initial factory settings. After clicking on the “Restore” button and confirming, the system
will restart and require the installer program to set up the network again.
“Calibrate”
Recalibrates the home position to the default center to recover the tolerance cased by some external forces. This function
is the same as the “Center” button on the remote controller. Please note that there is no confirmation message box after
clicking on the “Calibrate” button. The network camera will calibrate immediately.
43