Hawking Technology HNC720G - Manual (Page 9)

Software Installation
In this manual, "User" refers to anyone who has access to the network camera, and "Administrator" refers to anyone who
has access rights to configure the network camera and grant user access to it.
At the end of the hardware installation, the Administrator must insert the CD included with the package into the CD-ROM
drive of the PC. An auto-run program will appear (see below). If an auto-run window does not appear, go to the root
directory of the software CD and click on “autorun.exe”. Run the IP Setup program (see below) to locate the newly
installed network camera.
You will first need to install the Network Camera using a wired Ethernet connection before proceeding with the
wireless LAN configuration. Refer to the “Network Settings” section in the “Definitions in Configurations” chapter to
learn how to configure the wireless network settings.
On the packaging of the product, beneath the UPC code, as well as on the label that appears on the product, you will
find a sequence of four letters. Most Hawking network cameras with the sequence “HVVT” that are on standby awaiting
software installation will be located by the IP Setup program. (Hawking network cameras with other four-letter sequences
can be located by installer programs that correspond to their respective sequences.) Therefore, there may be several
entries shown in the window. Administrators can differentiate between the network cameras by MAC Address (also listed
as “Series Number”) and click on entries with the "Assigned" field labeled "No" to perform software installation. The
serial number is printed on the labels of the package as well as on the label on the network camera body.
9