Furuno GP-3300 - Manual (Page 50)

4-3
4. Enter latitude.
Cancel entire line of data: Press the [CLR] key.
Change data: Place data input cursor on wrong data, and then
reenter data.
Switch coordinates: [+] key, changes coordinate to North or East,
[-] key, changes coordinate to South or West.
5. Place the data input cursor to the first digit of longitude and then
enter longitude.
6. Enter comment, if desired.
Note: Waypoint comment can be entered on the Waypoint List.
See 4.2 Entering a Waypoint Comment.
7. Press the [ENT] key.
Waypoint entry by cursor
1. Press the [WPT] key to display the REGISTER WAYPOINT
menu.
REGISTER WAYPOINT
MODE = CURSOR L/L OS POS. R/B LIST
WPT NO. =
− −
ENTER WAYPOINT NO., AND DESIGNATE WAYPOINT POSITION BY
USING CURSOR. + : DISPLAY
−
: NOT DISPLAY
Figure 4-3 REGISTER WAYPOINT menu
2. Select CURSOR from the MODE field, if it is not already se-
lected.
3. Select WPT NO.
4. Enter waypoint number in two digits. If the waypoint number is
07, for example, press [0] and [7].
Note 1: If the waypoint number is already used, “(USED)” appears
to alert you. You can enter a new number by pressing the [CLR]
key, or overwrite the waypoint number by going to step 5.
Note 2: You can register a waypoint without entering waypoint
number, in which case the unit automatically registers the waypoint
in the youngest, unused waypoint. For example, if waypoints 01,
02, 04 and 05 are used when you enter a waypoint without
designating waypoint number, the unit will automatically register
that waypoint as waypoint number 03.