Furuno GP-3300 - Manual (Page 63)

5-4
5. Select WPT NO.
6. Enter waypoint numbers.
7. Press the [ENT] key.
Creating routes with the cursor
1. Press the [ROUTE] to display the ROUTE NO. menu.
ROUTE NO.
MODE = CURSOR WAYPOINT ??? LIST
ROUTE NO. =
− −
ENTER ROUTE NO., AND SELECT WAYPOINTS,
PRESSING + KEY AFTER SELECTIONS.
PRESS ENT TO REGISTER.
Figure 5-5 ROUTE NO. menu
2. Enter route number in two digits. (Don’t press the [ENT] key
yet.)
3. Operate the trackball to place the cursor on L/L position desired
for first route waypoint.
4. Press [+]. If you want to cancel a point, press [-].
5. Repeat steps 3 and 4 to enter other points.
6. Press the [ENT] key. Route waypoints entered by the cursor are
marked with a yellow flag and connected with a green dashed
line.