Furuno GP-3300 - Manual (Page 52)

4-5
3. Select WPT NO.
4. Enter waypoint number in two digits.
5. Select the RANGE field.
6. Enter range.
7. Select the BEARING field.
8. Enter bearing.
9. Press the [ENT] key to calculate position. The latitude and longi-
tude position of the range and bearing entered appears on the
display.
10. Press the [ENT] key again to register the waypoint.
Waypoint entry by navigation aid
The “TO” waypoint selected on the navigation aid connected is auto-
matically sent to the GD/GP-3300 as an external waypoint.
4.2 Entering a Comment for a Waypoint
You can enter a comment for a waypoint in the WAYPOINT list. The
comment can consist of 10 alphanumeric characters.
1. Press the [MENU] key followed by the [1] key to display the
WAYPOINT LIST.
2. Press arrow keys to set data input cursor on the line desired in the
comments column.
3. Operate the trackball to circumscribe the first character for your
comment. You can switch between upper and lower case charac-
ters with the [ZOOM IN], [ZOOM OUT] keys. See Figure 4-6.
ZOOM
OUT
ZOOM
IN
This cursor
selects character.
(These are lower case characters.)
Figure 4-6 Characters available for use as a waypoint comment