Users manual, Figure 2-6. rear view – Fluke 2625A User Manual

Page 32

Advertising
background image

2620A, 2625A

Users Manual

2-8

Table 2-1. Display Annunciators (cont)

"1"

Lit when alarm limit 1 is being defined. Also lit when displaying a measurement
value (LAST, Monitor) which has exceeded alarm limit 1.

"2"

Lit when alarm limit 2 is being defined. Also lit when displaying a measurement
value (LAST, Monitor) which has exceeded alarm limit 2.

HI, LO

Identifies alarm limit sensing (high or low) during channel configuration. At other
times, identifies an alarm condition.

REVIEW

Indicates that review data is being displayed (used in conjunction with the MIN,
MAX, and LAST annunciators).

MIN, MAX

Indicates that the displayed value is the minimum (maximum) value measured on
this channel.

LAST

Indicates that the displayed value is the most recent scan measurement taken on
this channel.

PRN

Indicates that the autoprint function is enabled (to send readings to a printer) or the
memory storage function is on (to store readings in internal memory.) Internal
memory is available with Hydra Data Logger only.

F

Bright when memory storage is full, dim when memory storage is nearly full. Hydra
Data Logger only.

EXT

Indicates that external triggering (on the rear panel) is enabled.

TR

Indicates that internal triggering (from the monitor alarm) is enabled. Also used with
EXT when external triggering is enabled.

REM

Indicates that the instrument is under the remote control of one of the computer
interfaces.

CAL

Indicates that the instrument’s internal calibration constants have been corrupted.

COMPLIES FCC-15B

+

0

1 2 3 TR

0 1

2

3 4

5 6

7

Σ

9-16 V

DC PWR

!

+30V

90-264V

50/60 Hz
15VA

CAUTION

FOR FIRE PROTECTION REPLACE WITH T 1/8A 250V (SLOW) FUSE

ALARM OUTPUTS

DIGITAL I/O

MEETS 0871 B

RS-232C

GND

DTR

TX

RX

IEEE STD-488 PORT

SH1, AH1, T5, L4, SR1, RL1, DC1, DT1, PP0, C0, E1

IEC 664 INSTALLATIONCATEGORY II

2620 2625

MODEL:

+ –

0

1 2 3 TR

EXTERNAL BATTERY

WARNING: If voltages greater than 30V are to be measured, a safety ground must be attached

to the rear panel ground connector when the instrument is operated from battery power.

oo06f.eps

Figure 2-6. Rear View

Advertising
This manual is related to the following products: