Fluke 2625A - Manual (Page 66)

2620A, 2625A
Users Manual
3-24
07:41:37 02/09/91
CH LAST VALUE MAX VALUE MIN VALUE
1: 097.32 mVDC 098.51 mVDC 096.10 mVDC
2: 0.0973 VDC 0.0985 VDC 0.0961 VDC
3: 00.097 VDC 00.099 VDC 00.096 VDC
4: 000.10 VDC 000.10 VDC 000.10 VDC
5: OL mVAC OL mVAC OL mVAC
6: OL VAC OL VAC OL VAC
7: 05.511 VAC 05.582 VAC 05.414 VAC
8: 005.51 VAC 005.58 VAC 005.41 VAC
9: OL OHMS OL OHMS OL OHMS
10: OL kOHMS OL kOHMS OL kOHMS
11: 08.276 kOHMS 08.374 kOHMS 08.231 kOHMS
12: 008.28 kOHMS 008.37 kOHMS 008.23 kOHMS
13: 0.0083 MOHMS 0.0084 MOHMS 0.0082 MOHMS
14: 00.008 MOHMS 00.008 MOHMS 00.008 MOHMS
15: OL HZ OL HZ OL HZ
16: 9.7193 kHZ 9.7239 kHZ 9.6771 kHZ
17: 09.719 kHZ 09.724 kHZ 09.677 kHZ
18: 009.72 kHZ 009.72 kHZ 009.68 kHZ
19: 0.0097 MHZ 0.0097 MHZ 0.0097 MHZ
With the Hydra Series II Data Logger (2625A), a sample Store printout of stored values
for three scans would be as follows:
07:41:5202/09/91
5: -3.2345 mMX+B12:123.87 kOHMS17:31.268VAC
ALM:15DIO:255TOTAL:0
07:41:5302/09/91
5: -3.2345 mMX+B12:123.87 kOHMS17:31.268VAC
ALM:15DIO:255TOTAL:0
07:41:5402/09/91
5: -3.2345 mMX+B12:123.87 kOHMS17:31.268VAC
ALM:15DIO:255TOTAL:0
The Hydra Series II Data Logger can hold 2047 scans, with each scan containing 21
channels of data.
Table 3-16. List Button Operation
(Note1) (Note 2) (Note 3)
Press these buttons:
L G
D
E
To select from these
choices: LASt
StorE
Note 1. RS-232 computer interface must be active. If the IEEE-488 interface is active, an error results.
Note 2. "LASt" prints out all values in the Review array. Review array values are not affected. An error
results if Review array data has been cleared.
"StorE" prints out logged scan data from the Hydra Data Logger (2620A) memory. Logged data is
not affected. An error results if there is no logged data.
Note 3. Press
C
to abort a printout while it is occurring.