Grizzly G0605X/G0606X - Manual (Page 22)

-20-
G0605X/G0606X Extreme Series 12" Table Saw
5. While an assistant holds the extension table,
fasten the 91 3 /
8
" front rail to the extension
table with three flat head screws, flat washers
and hex nuts (
Figure 13). Finger tighten for
now.
6. Fasten the 79" rear rail to the extension table
with three cap screws, lock washers (out-
side), flat washers, and hex nuts (inside), as
shown in
Figure 14. Finger tighten for now.
Figure 13. Front rail/table fastener locations.
7. Align the table and extension table with a
straightedge ( Figure 15), then tighten the
fasteners in Figure 13 with a 5mm hex
wrench and 12mm wrench.
Figure 14. Rear rail/table fastener locations.
8. Repeat the aligning procedure and tighten
the fasteners in Figure 14 with a 6mm hex
wrench and 12mm wrench.
9. Using a 17mm wrench, tighten the hex bolts
shown in Figure 12.
10. Thread a 3 ⁄
8
-16 hex nut on each foot and
thread the feet into the bottom of the support
legs as shown in
Figure 16.
Figure 16. Foot installed on support leg.
Figure 15. Aligning main extension table.
Foot
Support Leg
Hex Nut