Grizzly G0605X/G0606X - Manual (Page 25)

G0605X/G0606X Extreme Series 12" Table Saw
-23-
Arbor
A 1" or 5 /
8
" arbor can be installed on the table
saw, depending upon the arbor size of the blade
you want to install.
To change the arbor:
1. DISCONNECT THE SAW FROM POWER!
2. Remove the table insert, blade guard and
splitter or riving knife, arbor nut, arbor flange,
and blade.
3. Raise the arbor all the way up.
4. Hold the arbor shaft with the arbor wrench
and, using a 5mm hex wrench, remove the
cap screw from the end of the arbor, as
shown in
Figure 23.
Figure 23. Removing arbor.
Note: Gently tap the arbor with a rubber mal-
let to unseat it if it is hard to remove.
5. Slide the arbor out of the arbor shaft and rein-
stall the new arbor in the same manner that
the old one was removed. Make sure the new
arbor is securely tightened in the arbor shaft
before reinstalling the blade.
Arbor
Table Insert
You MUST install the table insert before operating
the table saw.
Components and Hardware Needed: Qty
Table Insert ........................................................1
Flat Head Screw M5-.8 x 20 ............................. 1
To install and adjust the table insert:
1. DISCONNECT THE SAW FROM POWER!
2. Place the table insert into the table and tight-
en the screw shown in Figure 24.
Figure 24. Table insert screw.
Table Insert
Screw
Note: Do not overtighten the table insert
screw. If you have questions, contact
Technical Support.
3. Place a straightedge across the table and the
table insert.
4. Use a 3mm hex wrench and straightedge to
adjust the table insert flush with the table as
shown in
Figure 25.
Figure 25. Adjusting the table insert.
The table insert must be flush with the table top or
the workpiece will hit the edge of the table insert
at the beginning of the cut.
Arbor Wrench