Grizzly G0605X/G0606X - Manual (Page 28)

-26-
G0605X/G0606X Extreme Series 12" Table Saw
Fence Components
Components and Hardware Needed: Qty
Fence Knob ....................................................... 1
Fence Resting Brackets .................................... 2
Flange Bolts M8-1.25 x 12 ................................. 2
To install the fence knobs, fence, and fence
resting brackets:
1. Install the fence knob as shown in Figure
32.
Figure 32. Fence knob installed.
2. Install the fence onto the table to the right of
the blade.
3. Check for fence parallelism and adjust if
needed. See Adjusting Fence on Page 54.
4. Install the fence resting brackets (Figure
33) onto the back of the cabinet with the two
flange bolts.
Figure 33. Fence resting brackets installed.
Brackets
Dust Collection
DO NOT operate the Model G0605X/G0606X
without an adequate dust collection system.
This saw creates substantial amounts of
wood dust while operating. Failure to use a
dust collection system can result in short
and long-term respiratory illness.
Components and Hardware Needed: Qty
4" Dust Hose (not included) ...............................1
4" Hose Clamp (not included) ............................2
Dust Collection System (not included) ...............1
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must take into account
many variables, including the CFM rating of the
dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system. Explaining this cal-
culation is beyond the scope of this manual. If you
are unsure of your system, consult an expert or
purchase a good dust collection "how-to" book.
To connect a dust collection hose:
1. Fit the 4" dust hose over the dust port, as
shown in Figure 34, and secure in place with
a hose clamp.
2. Tug the hose to make sure it does not come
off. Note: A tight fit is necessary for proper
performance.
Figure 34. Dust hose attached to dust port.