Grizzly G0605X/G0606X - Manual (Page 27)

G0605X/G0606X Extreme Series 12" Table Saw
-25-
Riving Knife
Review this section, even if your saw riving knife
came pre-installed. You must install the riving
knife or the splitter and blade guard before operat-
ing the table saw.
Components and Hardware Needed: Qty
Riving Knife ....................................................... 1
To install the riving knife:
1. Remove the table insert, blade guard, and
splitter—if previously installed.
2. Loosen the hex bolt (Figure 29), insert the
riving knife into the bracket slot, and tighten
the hex bolt to secure the riving knife.
3. Reinstall and secure the table insert.
Figure 29. Riving knife installed.
Components and Hardware Needed: Qty
Safety Pin .......................................................... 1
Flange Bolts M8-1.25 x 25 ................................ 2
To install the switch:
1. Fasten the switch to the left end of the front
rail with two flange bolts, and install the anti-
start safety pin as shown in
Figure 30.
On/Off Switch
Bracket
Riving Knife
Hex Bolt
Figure 30. Switch installed.
Stop Paddle
Flange Bolt
Anti-Start
Safety Pin
Figure 31. Miter gauge installed.
Washer
Handle
2. Slide the miter gauge into the miter gauge
slot to the left of the blade; or store it tempo-
rarily on the brackets near the blade angle
handwheel.
Components and Hardware Needed: Qty
Miter Gauge ....................................................... 1
Miter Gauge Handle .......................................... 1
Flat Washer 8mm .............................................. 1
To install the miter gauge:
1. Install the miter gauge handle and 8mm flat
washer onto the miter gauge as shown in
Figure 31.
Miter Gauge