Grizzly G0605X/G0606X - Manual (Page 52)

-50-
G0605X/G0606X Extreme Series 12" Table Saw
Blade Tilt Stops
The table saw features stop bolts that stop the
blade exactly at 45° and 90° during blade adjust-
ments.
The stops have been set at the factory and
should require no adjustments, unless you notice
that your cuts are not accurate.
Tools Needed Qty
90 ° Square ........................................................ 1
Combo Square .................................................. 1
Wrench 12mm ................................................... 1
Hex Wrench 4mm .............................................. 1
Hex Wrench 5mm .............................................. 1
To set the 90° stop bolt:
1. DISCONNECT THE SAW FROM POWER!
2. Position the blade tilt to zero (see indicator
on the front of the saw), and raise the blade
several inches above the table.
3. Place a machinist’s square against the table
and blade so it contacts the blade evenly from
bottom to top. Make sure a blade tooth does
not obstruct the movement of the square.
—If the blade is 90° to the table when the
stop bolt contacts the underside of the
table, go to
To Set the 45° Stop Bolt.
—If the blade is not 90° to the table, you will
need to adjust the 90° stop bolt.
4. Tilt the blade to 20° to access the 90° stop
bolt under the table.
5. Open the motor access cover, loosen the jam
nut shown in Figures 71 & 72, adjust the
stop bolt up or down, and repeat Steps 2-3
until the stop bolt contacts the table when the
blade is at 0°.
Figure 72. 90° stop bolt and jam nut (table
removed for clarity).
90° Stop Bolt
& Jam Nut
6. Tighten the jam nut.
To set the 45° stop bolt:
1. Repeat Steps 1-3 from the previous set of
steps using a combo square set to 45 °.
—If the blade is 45 ° to the table when the
stop bolt contacts the cabinet, go to To
Adjust the Tilt Indicator Arrow.
—If the blade is not 45° to the table go to
Step 2.
2. Remove the blade height lock knob and
handwheel.
3. Move the blade angle to 30°, or remove
the panel on the right side of the cabinet to
access the 45
° stop bolt.
Figure 71. 90° stop bolt and jam nut.
90° Stop Bolt
& Jam Nut