Grizzly G0605X/G0606X - Manual (Page 26)

-24-
G0605X/G0606X Extreme Series 12" Table Saw
4. While lifting up on the splitter pawls, insert the
splitter into the bracket slot, and tighten the
hex bolt to lock the splitter.
5. Reinstall the table insert and secure it with
the screw removed in Step 2.
Figure 26. Splitter installed.
Blade Guard and
Splitter
You MUST install the blade guard and splitter
before operating the table saw.
Components and Hardware Needed: Qty
Splitter ............................................................... 1
Blade Guard ...................................................... 1
To install the blade guard:
1. DISCONNECT THE SAW FROM POWER!
2. Raise the blade up all the way, unscrew the
screw on the table insert, and remove the
insert.
3. Using an arbor wrench, loosen the hex bolt
shown in Figure 26.
7. Swing the covers down to guard the blade.
Figure 27. Installing blade guard on splitter.
Notches
Bracket Screws
Figure 28. Blade guard installed.
Cover
Flap
6. Slide the bracket screws shown in Figure
27 into the notches on the splitter, push the
guard toward the back of the table, and tight-
en the lock knob (
Figure 28). If you have dif-
ficulty sliding the blade guard bracket screws
(
Figure 27) into the notches on the splitter,
loosen the bracket screws just enough so the
guard fits on the splitter.
Note: Make sure the clear plastic flap is
pushed toward the inside of the guard.
Lock knob
Hex Bolt
Splitter
Bracket
Pawls