GE GEFanuc Automation Programmable Control Products TCP/IP Ethernet Communications for the Series 90t-70 PLC GFK-1004B - Manual (Page 80)

3
3-28 TCP/IP Ethernet Communications User’s Manual – January 1996 GFK-1004B
Buffer Size Pool 1 < Buffer Size Pool2 < Buffer Size Pool3 < Buffer Size Pool 4
The ranges for the Buffer Pool Parameter values are:
BUFFER_POOL_1 - Buffer Pool 1 memory allocation
BUFFER SIZE - Valid range of 1 to 1024 bytes. Defaults to 44. Corresponds to
Station Manager Parameter bbuff1.
MEMORY ALLOCATION - Valid range of 1 to 97 percent. Defaults to 11 percent.
Corresponds to Station Manager Parameter balloc1.
BUFFER_POOL_2 - Buffer Pool 2 memory allocation
BUFFER SIZE - Valid range of 1 to 2048 bytes. Defaults to 380. Corresponds to
Station Manager Parameter bbuff2.
MEMORY ALLOCATION - Valid range of 1 to 97 percent. Defaults to 12 percent.
Corresponds to Station Manager Parameter balloc2
BUFFER_POOL_3 - Buffer Pool 3 memory allocation
BUFFER SIZE - Valid range of 1 to 4096 bytes. Defaults to 1580. Corresponds to
Station Manager Parameter bbuff3.
MEMORY ALLOCATION - Valid range of 1 to 97 percent. Defaults to 43 percent.
Corresponds to Station Manager Parameter balloc3
BUFFER_POOL_4 - Buffer Pool 4 memory allocation
BUFFER SIZE - Valid range of 1 to 8192 bytes. Defaults to 2140. Corresponds to
Station Manager Parameter bbuff4.
MEMORY ALLOCATION - Valid range of 1 to 97 percent. Defaults to 34 percent.
Corresponds to Station Manager Parameter balloc4.
The Station Manager Parameters are as follows:
PASSWORD - The password that is used to modify the secure mode of the Station Man-
ager. Case sensitive. Consists of up to 8 characters. Defaults to “system” (lower
case).
LSAP - The Station Manager Link Service Access Point (LSAP) to be used to send and
receive Station Manager REMote commands and responses. Defaults to E8 (hexade-
cimal). Corresponds to Station Manager Parameter bremlsap.
PRIORITY - The Link Layer priority used to send Station Manager REMote commands
and responses. Valid range of 0 to 7. Defaults to 0. Corresponds to Station Manager
Parameter brempri.