Motorola Series Switch WS5100 - Manual (Page 13)

Overview 1-3
1.1.2.1 Start Up
1.1.2.2 Primary
1.1.2.3 Standby
1.1.2.4 Error Codes
1.1.3 10/100/1000 Port Status LED Codes
A WS5100 Series Switch has two LED indicators for its RJ-45 ports:
• Upper left (amber/green) for link rate
• Upper right (green) for link activity
The following table provides additional information about the status of the 10/100/1000 Port Status LEDs.
Event Top LED Bottom LED
Power off Off Off
Power On Self Test (POST) running All colors in rotation All colors in rotation
POST succeeded Blue solid Blue solid
Event Top LED Bottom LED
Active (Continually Adopting Access Ports) Blue blinking Blue solid
No License to Adopt Amber blinking Amber blinking
Event Top LED Bottom LED
Active (Failed Over and Adopting Ports) Blue blinking Blue blinking
Active (Not Failed Over) Blue blinking Amber solid
Event Top LED Bottom LED
POST failed (critical error) Red blinking Red blinking
Software initialization failed Amber solid Off
Country code not configured.
Note: During first time setup, the LEDs will remain
in this state until the country code is configured.
Amber solid Amber blinking
No access ports have been adopted Blue blinking Amber blinking