4 adding an ntp neighbor, 4 adding an ntp neighbor -21, Adding an ntp neighbor – Motorola Series Switch WS5100 User Manual
Page 191
Switch Services
5-21
5.3.4 Adding an NTP Neighbor
To add a new NTP peer or server neighbor configuration to those available to the switch for synchronization:
1. Select
Services
>
Secure NTP
from the main menu tree.
2. Select the
NTP Neighbor
tab.
3. Click the
Add
button.
4. Select the
Peer
checkbox if the SNTP neighbor is a peer to the switch (non FTP server) within the switch’s
current subnet.
5. Select the
Server
checkbox if the neighbor is a server within the switch’s current subnet.
6. Select the
Broadcast Server
checkbox to allow the switch to listen over the network for NTP broadcast
traffic.
The switch’s NTP configuration can be defined to use broadcast messages instead of messaging between
fixed NTP synchronization resource addresses. Use a NTP broadcast to listen for NTP synchronization
packets within a network. To listen to NTP broadcast traffic, the broadcast server (and switch) must be
on the same subnet. NTP broadcasts reduces configuration complexity since both the switch and its NTP
resources can be configured to send and receive broadcast messages.
7. Enter the
IP Address
of the peer or server providing SNTP synchronization with this configuration.
8. Select the
Hostname
checkbox to assign a hostname to the server or peer for further differentiation of
other devices with a similar configuration.
NOTE: If this checkbox is selected, the AutoKey Authentication checkbox is disabled, and
the switch is required to use Symmetric Key Authentication for credential verification with
its NTP resource. Additionally, if this option is selected, the broadcast server cannot be
selected as a preferred source.