Motorola and V.32bis User Manual
Page 149
Configuration Quick Reference A-27
C
onfiguration
Q
uick-Reference
AT
*
PT2
=Auto
The auto-call unit attempts to tone dial when initiating a call. If tone dialing is not possible,
pulse dialing is used.
For this feature to work correctly, the first character in a dial string must be a digit. A T or P in
the dial string overrides this setting, for that dial string.
AT
*
PWx/y
Change Pass-
word
Lets you change the modem’s password. Enter:
AT
*
PWold password/new password<CR>
If successful, the modem responds with OK
Rmt Acc
Remote Access
Determines whether your modem can be configured by a remote modem.
AT
*
RA0
=Disable
The local modem cannot be configured by a remote modem.
AT
*
RA1
=Enable
The local modem can be configured by a remote modem.
Rmt Cnfg
Initiate/Terminate, or Abort Remote Configuration Session
Lets you initiate, terminate, or abort a remote configuration session with the connected modem.
AT
*
RC0
=Terminate
The modem terminates a remote configuration session with the connected modem. Changes to
the remote modem’s configuration are saved. This setting is not displayed unless you are
already in a remote configuration session.
AT
*
RC1
=Abort
The modem aborts a remote configuration session with the connected modem. Changes made
to the remote modem’s configuration are not saved. This setting is not displayed unless you are
already in a remote configuration session.
AT
*
RC2
Init Rmt Cnfg?
The modem attempts to initiate a remote configuration session with the connected modem. For
instructions on initiating a remote configuration session with a dial/leased line modem, or
terminating or aborting a remote configuration session, refer to Chapter 1 of the 326X Series
Modem Reference Guide.
AT
*
RDn
Redial Last
Number
With this command, the modem redials a call until a successful connection is made or the call
has been attempted n times. This command causes your modem to redial the last number
dialed.
Restore
Initiate/Terminate Restoral
Determines how modems operating on a leased line handle initiation of a dial restoral session.
The modem has four ways of initiating restoral: automatic, manual, DTE signal, or DTE ACU.
The restoral option is available in models: 3261, 3263, 3266, and the 3268.
AT
*
RE0
=Off
Disables the initiation of restoral.
AT
*
RE1
Restore=FP Only Manual initiation lets you initiate and terminate restoral by pressing the Talk/Data key (
key
in the Home position) on the modem’s front panel.
AT
*
RE2
=FP/108.1
The modem lets the DTE initiate restoral using DTR. In DTR restoral, an off-to-on DTR
transition from the DTE interface initiates restoral. This option is provided for DTEs that
cannot manipulate Circuit 116 for restoral purposes.
AT
*
RE3
=FP/116
The modem allows the DTE to initiate restoral with Circuit 116. Circuit 116 lets you use off-to-
on transitions of this signal from the DTE to initiate restoral, according to ITU V.24
specifications.
AT
*
RE4
=FP/Auto
In automatic restoral, the originating modem on the leased line determines when restoral takes
place. The answer modem cannot automatically initiate restoral; it can only answer an inbound
call, thus ensuring that both modems do not try to call each other at the same time. Such an
occurrence would result in a failed restoral attempt.
Table A-1.
AT Commands, Cross-Referenced to Front Panel Options (Continued)
AT
Command
Parameter &
Option
Description
Gray shading indicates country-specific options. See Appendix C for your country’s options.