Motorola and V.32bis - Manual (Page 235)

Index
Index-1
3-5
Symbols
+++ (AT escape sequence) 5-5
, 5-13
<> 5-13
= 3-5
@ dial modifier 5-12
Numerics
35XX device 4-25
A
A/ 5-7
A/B LED 3-4
AC Detect (S-Register 98) 5-18
Access security
lead digit delay timeout (S-Register 46) 5-16
tone duration (S-Register 45) 5-16
Adaptive Rate System 1-7
Adaptive rate system 1-7
ALM LED 3-4
Always= C-4
answer incoming call 5-6
APPC/APPN 4-21
Application examples
SDC 4-24
V.32bis and V.34 4-22
asynch data format 3-2
asynchronous host computer 4-18
AT 5-3
AT ACU
configure and operate modem 3-8
AT co mmand set 5-2
AT commands 1-6
+++ (escape sequence) 5-5
=x, Change S-Register Value 5-10
?, Display S-Register Value 5-10
A, Manual Answer 5-7
A/, Autobaud 5-5 , 5-7
and autobaud feature 5-5
cross-referenced to front panel options A-2
D, Dial 5-7
entering 5-3
errors in entry 5-4
H, Hang Up 5-8
I, Display Software Information 5-8
O, Leave Command Mode 5-8
result codes A-41
Sn=x, Change S-Register Value 5-10
Sn?, Display S-Register Value 5-9
X, Call Progress 5-7
Australia C-6
Austria C-6
Auto Call Unit (ACU)
LPDA-2 1-4
V.25bis 1-4
Autobaud 5-5
autobaud 5-5
Autobaud feature 5-5
using the A/ command 5-7
automatic call units (ACUs) 1-2
Automode/multimode feature 1-6
Avertissement xvi
B
BABT regulations
Hong Kong C-32
backplanes 2-5
Backspace character (S-Register 5) 5-12
bandwidth on demand 4-18
Belgium C-6
Bell 801C ACU 3-10
Besondere Hinweise
Beschreibung xvi
Blind dialing
Denmark C-32
blind dialing 5-12
bridge 4-18
British Telecom C-36
Buffer delay
during disconnect 5-16
bulletin board 4-18
BUSY message A-41
busy out 5-8 , A-44
C
cables 2-4
Cabling
daisy-chain 2-13
modem 2-11
NMS 2-13
Cabling overview
Figure 2-5 3260/65 2-11
Figure 2-6 3261/66 2-12
Call establishment methods 3-10
Call progress